Spray Painted my exhaust tips

[ducktapeonmydesk]

I believe I used 320 grit, but it doesn’t have to be exact. You just need to scratch them up so the paint will adhere. I then blew them off and rubbed them down with alcohol. VHT says to wait 10 minutes in between each coat so that’s what I did and 30 minutes before applying the clearcoat after the final coat of color. The next day, I rubbed them down with zero steel wool and some polishing compound, then followed up with some ceramic coat wax. The whole process only took a couple of hours. The longest part was making sure everything was masked off, and that took probably an hour and a half because I didn’t want any overspray anywhere.

Thank you!

If you had to do it again, would unbolt and remove them or mask everything off again?

Sponsored

 

[Bigmess]

Thank you!

If you had to do it again, would unbolt and remove them or mask everything off again?

I would definitely mask everything, it looked like more work to unbolt and remove, then when you reinstall it may be hard to get back in without scratching it up. It’s not that bad to mask it off, but I can understand if you wanted to remove as well. Good luck!

 

[805 Ranger Raptor]

That’s how it should have came from the factory with black tips

 

[Kidbullets]

Repeated the process as described and everything turned out perfectly .... but ... watch out for taking that tape off too early. I got impatient and took off the tape and a piece of it touched the right exhaust tip and pulled a small amount of paint off. It's almost impossible to notice, but of course I can't stop kicking myself for taking everything off too soon. I only waited 45 minutes after the last coat. Should have waited a few hours and been more careful.

Really looks great though. Very happy with the final look.

How’s this holding up.?

Sponsored