Lifted and leveled 2024 Ranger Raptor

[BigMeatsBronco]

Installed a 1.75" spacer in front and 1.25" in rear.
leveled the rake out ALOT.

total lift is 2.375" front and
1.5" rear.

very happy with the results.

Sponsored

 

[ALCO44]

Installed a 1.75" spacer in front and 1.25" in rear.
leveled the rake out ALOT.

total lift is 2.375" front and
1.5" rear.

very happy with the results.

Which spacer lift did you use ?

 

[Ford Motor Company]

Installed a 1.75" spacer in front and 1.25" in rear.
leveled the rake out ALOT.

total lift is 2.375" front and
1.5" rear.

very happy with the results.

Looking good! Loved what you did with your truck!

 

[Arsenall11]

How has the ride changed? Thx

 

[BigMeatsBronco]

How has the ride changed? Thx

Great ride...a tad more body roll now ( as to be expected) haven't noticed any difference in suspension stiffness....I was wonding about needing to reset the ride height in forscan , but so far I don't think it's necessary.

 

[BigMeatsBronco]

Which spacer lift did you use ?

I used a readylift in the front and a Fabtech on the rear.

 

[Arsenall11]

So the Fabtech bronco spacer works, good to know!

 

[Duckfart]

Installed a 1.75" spacer in front and 1.25" in rear.
leveled the rake out ALOT.

total lift is 2.375" front and
1.5" rear.

very happy with the results.

I'm digging that half cab Bronco!!!

 

[Desertrunner21]

Wait, the picture shows 1.5” lift front kit..
You used that for the rear?
Need clarification cause I am looking for a spacer kit for the front myself.
I’m only looking for 1.5 for the front to keep my rake slightly but not leveled.

 

[BigMeatsBronco]

the Fabtech 1.5 will raise either front or rear end this amount...approximately. the angle of the coilover is slightly different front to rear, so is the ratio.

 

[Arsenall11]

Did you need to pull the axle out of the hub to install? Thx

 

[BigMeatsBronco]

Did you need to pull the axle out of the hub to install? Thx

nope

 

[Arsenall11]

Nice, sounds like an easy install, thx

 

[schapstic]

Why didn't you just use the Readylift all around? Did you need to have an alignment after the install?

 

[BigMeatsBronco]

Why didn't you just use the Readylift all around? Did you need to have an alignment after the install?

Because I did not want to lift the rear a full 2 and 1/2 in.
I already had the Fabtech ones from previously using them on my Bronco.
We did take it in for alignment but it wasn't necessary after looking at the paperwork

Sponsored