Bak X4S + Kuat Ibex - The forbidden tonneau/bed rack combo

[theHolographicP]

Here's the 3D file I made for the bed shim, although I never actually tested this fitment. Drilling the holes in the shims, I put them in place and marked the holes from below. Drilled oversized holes through the shims to make fitment easier. Drilling the holes through the rack was alot of eyeballing and measuring with calipers, measuring twice and drilling once. You don't have a little of wiggle room on where that bolt goes through the profile of the aluminum extrusion.

https://www.thingiverse.com/thing:6948727

Appreciate it! If I end up measuring and drawing it instead of drilling from template I'll drop the info off here for other folks.

Sponsored