Signature Lux Grill Lights

[patc890]

Received my Signature Lux grill lights. Well constructed flush fitting lights.

Simple kit and instructions. Provides two different hook ups, either via the Aux #1 wiring harness or Aux #2 fuse box.

Looking forward to installing them next week along with the Fog Lamps. Post more once installed.

Are these the amber only lights or the amber/white ones?

Sponsored

 

[RANGER/HOBB]

Mine are white, however you can get them in amber/white or amber.

 

[patc890]

Mine are white, however you. An get them in amber/white or amber.

Thanks. They sent me both as I wasn't sure which I wanted. They also look different so I wan't sure which was which. So you said yours are white then larger ones are white? See my photos below.

 

[jskrillz]

There is an option in the instructions to do just that. Not complicated at all. I was on the fence and but went with Aux 1 as I’m not sure that I may want to “turn them off.”
I just leave aux 1 on so when I start the truck they are on.

Is aux 1 powered when the truck is off? For some reason I thought it was. I want to do the same but don’t want my battery to die when the truck is off if the lights stay powered.

 

[BHunted1]

Is aux 1 powered when the truck is off? For some reason I thought it was. I want to do the same but don’t want my battery to die when the truck is off if the lights stay powered.

No...... I leave switch 1 on... no prob.
If you are going to want at least the amber on always, run a line to the sidelights in the side of the front fender. Why waste a switch?

 

[BHunted1]

Received my Signature Lux grill lights. Well constructed flush fitting lights.

Simple kit and instructions. Provides two different hook ups, either via the Aux #1 wiring harness or Aux #2 fuse box.

Looking forward to installing them next week along with the Fog Lamps. Post more once installed.

These, (or any other market brands), look huge in the photo.
They actually fit nice in those upper holes? (first row above camera)?
Those holes are sort of diamond shaped inside and don't have a flat back surface....

 

[BHunted1]

3M has an adhesive that is used on most of the Air Design spoilers. It’s black and sets very quickly. This same adhesive can be used on the rear of the lights when they’re set in place. It’s waterproof and holds far better than any silicone available.

It can be purchased on Amazon.

Good stuff, but once it's on, you'll never get it off. bulb dies; it would be a biotch.

Sponsored