In Bed Power specs

[Harrington]

Does anyone have the specs for the in bed power? Specifically the height/location of it in the bed? I was planning on getting a decked drawer system when the truck comes but it dawned on me that the drawer system might block the power outlets?

Sponsored

 

[jedadiah]

Here are the Ford Instructions for their Decked System The outlets show up in a few of the diagrams, but there's no mention of interference anywhere in the instructions.

 

[MAV]

The subject of this thread made me think of something totally different...

 

[Harrington]

Ended up contacting Decked, from my understanding the plugs are usable with the tailgate open, or if you take out the stash bin before the wheel well on the driver side. If anyone was thinking of going this route it is nice to know you aren't losing that power source in the back of the truck.

 

[Jlawson865]

Ended up contacting Decked, from my understanding the plugs are usable with the tailgate open, or if you take out the stash bin before the wheel well on the driver side. If anyone was thinking of going this route it is nice to know you aren't losing that power source in the back of the truck.

THANK YOU! I tried asking about this in a Facebook group and I couldn't get an answer....good to know because I too am planning on ordering from DECKED

 

[jedadiah]

Ford finally updated the pictures of the Decked system on the Ford accessories page, but made sure every picture shows the right side of the bed.

 

[Harrington]

I love that they are also selling it for a solid $900 more than decked is selling it!

 

[Harrington]

Looking at these 2 pictures side by side, it might work? but it seems very close

 

[StillwaterRaptor]

I just installed the decked system and took some closeups of the power area. They ship the sides notched to maintain access.

hope this helps

 

[Harrington]

I just installed the decked system and took some closeups of the power area. They ship the sides notched to maintain access.

hope this helps

That's super helpful! Thanks so much

 

[StillwaterRaptor]

As a heads up if your bed is lined from the factory getting the front tiedowns off really does suck. You can either try and get the bedliner off the bolt heads or deadblow hammer a T40 Torx into the bolts.
I ended up messing up 1 head and replaced all bolts with other ford hardware. Used some channel locks to get the bolts out.
Only the cab side tied downs get replaced.

 

[Harrington]

As a heads up if your bed is lined from the factory getting the front tiedowns off really does suck. You can either try and get the bedliner off the bolt heads or deadblow hammer a T40 Torx into the bolts.
I ended up messing up 1 head and replaced all bolts with other ford hardware. Used some channel locks to get the bolts out.
Only the cab side tied downs get replaced.

Do you know what size torx head was needed to replace the factory tie down bolts?

 

[StillwaterRaptor]

T40

Sponsored