Search results

Totally understandable, which is why I wired it up to an auxiliary switching panel and I can turn them on/off individually whenever I want.

The 4 purple ones are RGB and change color as well as different modes such as chasing and smooth fading. The 3 amber are only one color. Both lights sit flush inside the grill. The RGB ones go inside from the back and are flush mounted while the amber ones only go in from the front and you have...

I drilled a hole into the fuse panel and used a rubber grommet along with sealant to feed the wire out from the fuse box. That was the only way to feed the wire out otherwise the panel won’t close fully.

Added a new strip to the hood and looks pretty good, haven’t wired the turn signal wires yet but if I do I will document an install on them. I am looking for the turn signal wire and hazard wire colors from the headlights if anyone has the wiring diagram please? The strip was about $15 and...

The aft two doors require a constant 12V power wire which is unavailable. The window switch as well as the speaker do not supply a constant 12V, so I am going to run a wire from the left side drivers fuse panel routed through the left and behind the seats over to the right side aft door panel. I...

I recently bought the symphony 20 in 1 RGB interior kit similar to the ambient lighting for the BMWs. Should I document my install since no one has attempted to do anything related to this. I have already installed and tested the kit on one of the door panels and it looks ungodly. I can’t tell...

Sounds cool. Do you have a print so I can try to replicate? If not then I just want to know where you mounted the inside of the plate to.

Can you link the front light bracket please?

Update to everyone. I ran a 16 gauge wire to my battery up front through the left side. Was super easy and straight forward. I wired it to a switch near the power panel in the back and attached the led lights to the switch as well.

Hello everyone. I have the gator efx hard trifold cover. Every time it rains, my bed is totally wet at all 4 corners and all along the sides of the bed. I used silicone sealant to seal all the corners as well as drilled two holes in the front of the cab where the two plugs are for the water...

Yes I have the aux switches but don't really want to wire bed lighting to them. I'm using them for bed and tail exterior light bars and pods such as a reverse light. Therefore I wanted to tap into anything in the bed of the truck and the power panel seemed like an easy spot. Other option was to...

I purchased this set of LED lighting on ebay. Its an led strip and just two wires at the end available to hardwire to a power source. In the bed of the truck there is a power panel with a US standard plug socket and a cigarette port socket. I went behind the panel and cut the cigarette port...

There's very little information I could find on the actual wiring of the upfitter switches. I ordered a light bar from ebay that comes with a wiring harness attached to a relay and a switch. I was going to cut the relay and switch off and just run the red light bar hot wire directly to the...