• Welcome to Ranger6G.com everyone!

    If you're joining us from Ranger5G, then you may already have an account here! As long as you were registered on Ranger5G as of March 27, 2020 or earlier, then you can simply login here with the same username and password.

Sponsored

Recent content by Franco

  1. FMI Bumper Bar, Baja Designs Bling and Third Brake Light Conversion on Ranger Raptor

    Not a bad idea, I might paint them. Some of those silver screws are actually the LED Brake lights
  2. Stake Pocket Plugs

    I just put on a bed cover and finally recognized the size of the opening. Maybe a stupid question but does a lot/can a lot of water come in from that opening?
  3. Stake Pocket Plugs

    Did you ever find any answers or resolution to this issue? Thanks
  4. FMI 2" Collars + Falken Wildpeak AT4 35/11.50/17 on 17x8.5 +25 offset KMC KM552 Wheels

    One last question - was on the Lux website. Which ones fit? The Wildtrak/XLT?
  5. FMI Bumper Bar, Baja Designs Bling and Third Brake Light Conversion on Ranger Raptor

    I only have 1200 miles on it so not sure about any long term issues (Never have had any with the numerous IFS vehicles I have done a similar lift to). No cutting if you remove the crash bars - These are not on the Bronco Raptor. Hope this helps
  6. FMI 2" Collars + Falken Wildpeak AT4 35/11.50/17 on 17x8.5 +25 offset KMC KM552 Wheels

    Yes I wanted to go 2.5 but I ultimately added some weight to the bed and am happy with its stance (Retractable bed cover and Yakima Overhaul HD racks)
  7. Removal of Raptor Decals

    Mine came off SUPER EASY and in one piece. Took literally two minutes If it's new just put the truck in the sun grab a corner and pull.
  8. FMI Bumper Bar, Baja Designs Bling and Third Brake Light Conversion on Ranger Raptor

    Thank you! Yes it does block the bottom a bit but for my use it's not really a concern. It probably would improve with just four but I really liked the look of five (Even tho it was more $$$)
  9. FMI Bumper Bar, Baja Designs Bling and Third Brake Light Conversion on Ranger Raptor

    Thank you! Yes it is at the lowest setting. It sits probably 1/2 inch lower without the bed cover if you are mounting it directly to the bed rails. Fitting in my garage was a must and it still does. I don't think it is any (or much) higher than the navigation fin. No noise that I can hear
  10. FMI Bumper Bar, Baja Designs Bling and Third Brake Light Conversion on Ranger Raptor

    Yes the SyneticUSA AR Retracable Pro - Works with Yakima Overhaul HD
  11. FMI Bumper Bar, Baja Designs Bling and Third Brake Light Conversion on Ranger Raptor

    Thanks they are KMC KM552 17x8.5 +25 offset. You can get them most any off road or wheel shop
  12. FMI Bumper Bar, Baja Designs Bling and Third Brake Light Conversion on Ranger Raptor

    Thank you! You can basically set them as you wish. They can work with the doors but I have them set up to the 5th and 6th Auxiliary Switches so they are on demand. There are also four small LED brake lights built in



Top